server side: laptop XP home, 1280x1024 res 32bit color, firewall off (if that matters), RealVNC 4.1 service mode (192.168.129.1). Default setting with password
client: opie-keypebble 1.0.0 Default setting (default set: request 8-bit session, scale factor 1) with password
Click "OK". at the bottom of my Z screen, says "Connected" but nothing happened afterwards. I've never used VNC on Z before, so what should I expect? Is this normal? Any hidden buttons I should click?
[div align=\"right\"][a href=\"index.php?act=findpost&pid=70480\"][{POST_SNAPBACK}][/a][/div]
Hi xjqian, have you had any luck?
Sorry about the slow responce, but the local telecomm here in Addis, has been "upgrading" their system... I have been without Internet acess for a while...
With the server, I recall having to tell it to accept the remote connection.
the settings on my z6kl are as follows:
Data Encoding section.
Check for Screen updates every: 50 Milliseconds.
[checked] Request 8-bit session.
[checked] Raise on bell.
[unchecked] Request shared session.
Connection section.
I have nothing checked.
Connect to VNC Server.
Hostname: [using an ip rather then resolving a name]
Display Number: 0
Password: xxxxx
let me know how it goes.
lek