6
« on: March 29, 2007, 11:53:59 am »
Hey all. In the constant saga of me breaking my Zaurus, I have a new chapter. About a month ago I took apart my in order to replace the microdrive which had finally died. Shortly after I decided to use my sd slot as I never had and I thought it would be nice to have some extra space. Well, after ejecting the mock card, I tried to press in the sd card and it felt like something was blocking the way. I tried a couple more times to no avail. Well, I accepted the fact it was broken and I stepped away from this problem for a week or so. Well, I noticed that, now when I booted up pdaxrom, no modules were loaded... In fact, I didn't even get a FAILED. So, again, I tried the sd card again and it pressed in after a bit of fiddling (not hard). When it went it, the system freezes for a short while and then acts as though nothing happened. I try to mount and no beans. I run dmesg and I get nothing (mind, the card is in now and ejects and presses in as normal). The reason I post this in the hardware section is because I just flashed to GPE and I still have the same problems (minus the short term freeze). I pop the card in, mounting fails and I get nothing in dmesg. Does anyone have a clue? Possibly a broken solder joint? The board is pressed into the socket on the motherboard and screwed down....
I never used my SD cards and now I feel like I am missing something HUGE on my Z.... It's funny how that works.
--Fish