Hi,
I've been very enthusiastic and purchased a 860 and a new D-Link DCF-660w card.
After playing around with pdaxrom I finally ended up with OpenZaurus 3.5.3 (and opie).
Unfortunatly I can't get the WLan-Card configured - to me it appears as if there is
a problem with loading the firmware.
The following modules are loaded:
# lsmod
Module Size Used by Not tainted
hostap_cs 56728 1 - Live 0xbf01d000
hostap 114408 1 hostap_cs, Live 0xbf000000
#
dmesg says:
hostap_cs: Registered netdevice wifi0
hostap_cs: index 0x01: Vcc 3.3, irq 40, io 0xc4860000-0xc486003f
hostap_cs: assuming no Primary image in flash - card initialization not completed
wifi0: test Genesis mode with HCR 0x1f
prism2_pccard_cor_sreset: original COR 00
prism2_pccard_genesis_sreset: original COR 00
Readback test failed, HCR 0x1f write 00 e1 a1 ff read 38 00 38 00
wifi0: test Genesis mode with HCR 0x0f
prism2_pccard_cor_sreset: original COR 00
prism2_pccard_genesis_sreset: original COR 00
Readback test failed, HCR 0x0f write 00 e1 a1 ff read 38 00 38 00
prism2_pccard_genesis_sreset: original COR 00
wifi0: registered netdevice wlan0
wlan0: cannot set RID fc02 (len=34) - no PRI f/w
wlan0: could not set interface UP - no PRI f/w
wlan0: could not set interface UP - no PRI f/w
wifi0: could not set interface UP - no PRI f/w
wifi0: could not set interface UP - no PRI f/w
wlan0: cannot set RID fc02 (len=34) - no PRI f/w
wlan0: could not set interface UP - no PRI f/w
wlan0: could not set interface UP - no PRI f/w
#
I manually tried to load a primary firmware (that came with OpenZaurus):
# prism2_srec wlan0 /etc/pcmcia/pm010102.hex
srec summary for pm010102.hex
Included file name: PM010102.HEX
Component: 0x0015 1.1.2 (primary firmware)
ioctl[PRISM2_IOCTL_HOSTAPD]: Inappropriate ioctl for device
Missing wlan component info
Could not read wlan RIDs
#
Do I need another firmware? Can anybody that managed to get this card running
on OpenZaurus 3.5.3 tell me how he accomplished that?
Thanks a lot for any help and hints!!!
Felix
