Author Topic: Mouse Jittering Too Much To Right Click  (Read 3012 times)

band-aid

  • Newbie
  • *
  • Posts: 35
    • View Profile
Mouse Jittering Too Much To Right Click
« on: December 10, 2007, 01:19:52 pm »
I've scoured the forums and now have right click via the calendar button working via xmonobut. Problem is, the mouse jitters so much that it detects my attempted right click as a right click and drag. I end up poking the spot five or six times until it clicks correctly. I have verified that the mouse is in fact jittering around in xournal. It works fine for a fraction of a second then flys half way across the screen then back to where it should be leaving a huge spike. Any suggestions?

Band-aid

I'm running Angstrom 2.6.23

jpmatrix

  • Hero Member
  • *****
  • Posts: 1014
    • View Profile
    • http://matrixmen.free.fr
Mouse Jittering Too Much To Right Click
« Reply #1 on: December 10, 2007, 02:39:42 pm »
Quote from: band-aid
I've scoured the forums and now have right click via the calendar button working via xmonobut. Problem is, the mouse jitters so much that it detects my attempted right click as a right click and drag. I end up poking the spot five or six times until it clicks correctly. I have verified that the mouse is in fact jittering around in xournal. It works fine for a fraction of a second then flys half way across the screen then back to where it should be leaving a huge spike. Any suggestions?

Band-aid

I'm running Angstrom 2.6.23

that's a little mystery : it doesn't jitter under angstrom but it jitters under eabi    
did you try to rmmod mousedev? this used to lower the jitter but sometimes it is back again....
**Fujitsu U1010 !!!  
**ex-Zaurus SL-C3000 owner with Debian kernel 2.6.24-yonggun

band-aid

  • Newbie
  • *
  • Posts: 35
    • View Profile
Mouse Jittering Too Much To Right Click
« Reply #2 on: December 10, 2007, 04:00:39 pm »
I'll try that, I think I was a bit confusing

I'm running Debian EABI using the angstrom kernel. Sorry for the confusion.

Band-aid

EDIT: xmonobut -k 67 stopped working so I switched it to -k 68. That worked until I restarted X, an now its not working. I'll post xev output in a bit.
« Last Edit: December 10, 2007, 04:12:15 pm by band-aid »