Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - usunoro

Pages: [1]
Yeah I've been using 18a since I installed c3kb1 as well (about 2mo ago) seems rock solid so far. My Ambicom card is detected properlly according to cardctl but when i used the eject applet it shows up as some Z-Com card.

C1000/3x00 Hardware / New With Zaurus. Wireless And Some Questions.
« on: October 07, 2005, 02:29:36 pm »
An easy way to keep it from suspending is to setup an adhoc network on the Zaurus.  I have to do it w/ my Ambicom 802.11b card to use Wellenreiter.  It doesnt really matter what the information for the network is, at least with Wellenreiter.

C1000/3x00 General discussions / C3000 Issues / Solutions
« on: July 20, 2005, 02:57:24 pm »
Yes, The instructions state that you should put a CF card in the slot before you partition. As stated by a previous poster, if you don't you'll end up with the internal disk being /dev/hda. I don't remember why at the moment, but I had difficulties when partitioning on /dev/hda. Let me know how it works out.
[div align=\"right\"][a href=\"index.php?act=findpost&pid=81335\"][{POST_SNAPBACK}][/a][/div]

I just recently restored using an SD card, and have seen no effects from having partitioned hda. At first it threw me for a loop though that hdc didn't exist, as there's no indication that may happen in the directions.

Pages: [1]