D-link Air 660w With Sharp 3.1 Rom?

[zaurusen]

Hi-

I just reflashed my SL-5500 with the Sharp 3.1 ROM.

After plugging in the D-Link Air DCF-660W card and configuring the
network settings using the "Network" wizard, the Z won't connect.

The MAC address to enable filtering on the router is unknown --
where can the MAC address for the card be found?

Thanks in advance.

[Crownsilver]

The MAC adress should be printed on the card. It is on mine. On my SL-C860 with Cacko 1.22 I had to disable Auto-connect to make it work.

[craigtyson]

Iv got the same card which works fine on tkc v1 (a 3.1 based rom)

One thing though the first ROM I downloaded was corrupt and some networking bits didnt work are you sure this image is OK or is this the first time youve used it?

[zaurusen]

Iv got the same card which works fine on tkc v1 (a 3.1 based rom)

One thing though the first ROM I downloaded was corrupt and some networking bits didnt work are you sure this image is OK or is this the first time youve used it?
[div align=\"right\"][a href=\"index.php?act=findpost&pid=66603\"][{POST_SNAPBACK}][/a][/div]

Yes, the first timeI've used this ROM. But if it was corrupted, wouldn't that
render the whole ROM useless, rather than destroy a certain part?

And this ROM was downloaded directly from Sharp [http://www.myzaurus.com/lic5500v31c.asp].

---------

Update: With the MAC filtering adjusted, the sl-5500 can connect.

[zaurusen]

The MAC adress should be printed on the card. It is on mine. On my SL-C860 with Cacko 1.22 I had to disable Auto-connect to make it work.
[div align=\"right\"][a href=\"index.php?act=findpost&pid=66589\"][{POST_SNAPBACK}][/a][/div]

Hi Crownsilver, just to let you know, I found the MAC address... hidden in plain sight.

And the Z can connect now. Happiness is.

Thanks.

For anyone else who may have the same question:
The MAC address is called the "Node ID" on the back of the card, located above the barcode and below the "FCC Tested to Comply" box.