OESF Portal | OESF Forum | OESF Wiki | LinuxPDA | #planetgemini chat on matrix.org | #gemini-pda chat on Freenode | #zaurus and #alarmz chat on Freenode | ELSI (coming soon) | Ibiblio


Welcome Guest ( Log In | Register )

> Replace Netwalker Lcd Or Battery (pc-z1), English Instructions
Tom Moulton
post Jul 10 2010, 02:44 PM
Post #1

Group: Members
Posts: 20
Joined: 25-June 10
From: Tampa, FL, USA
Member No.: 77,866

I figured I would post these disassembly steps for anyone else who needs to replace a cracked screen sad.gif

Read entire post before attempting on a real unit *** NOT COMPLETE YET ***

The only other info I found was in Japanese.

Remove the small plugs that cover the screws.
There are two sizes, the ones over Big(2) have a "3" in them, see a picture in my other post.

The two big ones are feet, not screw covers.

If you are only replacing the battery or LCD you only need to remove the Big (2) and Long (2) screws.

The screw heads are very small, Phillips size 00 (PH00)

Remove the Battery Cover, lift from the top.

This will expose the battery, which can come out of the channel, but is attached with a group of wires.

Since my battery is fine, I did not look for a connector or open the covering.
(Call me chicken, but I have enough problems right now)

To open the upper case there are two screws at the bottom next to the hinge/battery cover.

To be able to reach them with a screwdriver, close the lid most of the way, with the battery hanging down.

Here you can see the Strange screw head, along with the wires to the battery.

At this point I am stuck, until I find the proper screwdriver for this. ohmy.gif

Ok Wikipeadia says it is a Tri-Wing or Triangular Slotted blade.. But as with the PH00 is it SMALL
I found a small screwdriver set on ebay where they call it a Y Screwdriver. They mention other electronics,
like GBA etc.

We'll see if it fits when I get them...

I will update this when I learn more...

Go to the top of the page
+Quote Post
Start new topic
Tom Moulton
post Jul 17 2010, 05:34 AM
Post #2

Group: Members
Posts: 20
Joined: 25-June 10
From: Tampa, FL, USA
Member No.: 77,866

Well I have learned more and may have killed my WiFi sad.gif

After I removed the Y Screws I was able to unsnap the lid cover.
BTW those Y Screws also screw into the LCD Unit

The lid is held to the base with these arms, and these screws.
The pivots have a flat cable that is wrapped around the pivot..
The left one clearly has wires, the right one may not, it tore on me.
Now My WiFi does not work... cause and effect? Not sure.

The LCD Unit is held down by a few of these screws and large washers.

Here we see that is it a sealed unit (LCD, Glass and Touch Screen)

And the part number LQ050W1LADA 85D16732

I thought I had another picture with the SHARP logo on the PCB, I will have to check the camera.

From what I have seen, I think the best solution for a dead LCD is finding a unit with a dead base board sad.gif

I'd feel a lot better if this was my SECOND unit and not my only one sad.gif

Go to the top of the page
+Quote Post

Posts in this topic

Reply to this topicStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:


RSS Lo-Fi Version Time is now: 23rd May 2018 - 02:46 PM